Available: 4 pieces
Fall protection grilles in accordance with DGUV Rule 103-007, rectangular, made of stainless steel, universally applicable and retrofittable underneath shaft covers.
Fall protection grille made of angle profile, load capacity up to 200 kg.
Support made of angle profile, pre-prepared for doweling inside the shaft, below the shaft cover.
The fall protection grille is mounted below the shaft cover and above or next to the climbing system.
Fall protection grilles and supports welded under protective gas, pickled and passivated in an immersion bath.
Including appropriate fastening materials.
Features:
Material: 1.4307 (304L)
Design for shaft cover type: SD1 / 3 / 5 / 7
Clear shaft dimensions:
Dimensions: Hinge side x width (projection): 950 mm x 1700 mm